直流電橋自動化檢定系統設計

肖純[1] 彭云鵑[1] 方長全[2]
[1]武漢理工大學自動化學院,武漢430070 [2]武漢理工大學大慶同力機電有限公司,武漢430070
摘　要:本文旨在建立直流電橋自動檢定系統的硬件環境。根據電橋檢定規程編制測量軟件。分析檢測數據，實現直流電橋的自動檢定，并根據檢定結果打印規范化的檢定證書。該系統采用Fluke公司的多功能信號發生器Fluke5520A輸出高精度的標準電阻來進行電橋檢定。計算機與Fluke5520A信號發生器之間的通信采用GPIB總線技術。設計了基于VB6．0的計量軟件，重點介紹了GPIB通信技術的編程。該系統簡化了檢定過程、提高了工作效率并避免了手工操作時人為差錯的可能性。[著者文摘]

Design of DC bridges automatic verification systemXIAO Chun, PENG Yun-juan, FANG Chuang-quan 1. School of Automation,Wuhan University of Technology,Wuhan 430070,China;2. Daqingtongli Machinery and Electricity CO. LTD., Wuhan University of Technology, Wuhan 430070,ChinaAbstract:automatic The aim of this paper was to establish the hardware frame of DC bridges verification, to program by Verification Regulation of the DC bridges, to analysis the data and to realize the automatic verification and print the report. This system used Fluke 5520A as a multi-functional signal generator which can output standard resistance to calibrate DC bridges. GPIB bus technology was applied between computer and Fluke 5520A. Software design was based on VB6.0. The program technology on GPIB program technique was introduced especially. The system changed the tradition manual operation, simplified the calibration process, enhanced the working efficiency and has avoided the human error.[著者文摘]

Key words:DC Bridges automatic verification system;GPIB;Fluke5520A;Measurement