大型鍛件幾何尺寸非接觸在線測量系統研究

劉勇 黃劫 李揚揚 鄭路遙 楊府
四川大學制造科學與工程學院,四川成都610065
摘　要:針對我國大多數鍛件生產廠測量鍛件技術落后，測量環境惡劣，人工測量誤差較大的現狀，分析了基于CCD器件尺寸測量的原理，提出了一種運用數字圖像處理的非接觸在線測量鍛件尺寸的方案，同時運用高級語言編寫系統軟件，并分析了該方案測量誤差的計算方法。實驗結果表明該方案價格低廉，操作簡單，適應性廣且測量結果能達到實際要求。[著者文摘]


Research of on-line non-contact geometry measurement system for large forging partsLIU Yong, HUANG Jie, LI Yang-yang, ZHENG Lu-yao, YANG Fu School of Manufacturing Science and Engineering, Sichuan University, Chengdu 610065, ChinaAbstract:In our country, the measurement technology of forging parts in most of forging plants is poorly developed, its measurement environments are harmful, and the artificial measurements cause great errors. When these are taken into consideration, an on-line non-contact geometry measurement scheme was proposed with the digital image process technology according to the principle of size measurement based on the CCD（Charge Coupled Devices）. The software system was written by senior language, at the same time the calculation of the error produced in this scheme was analyzed. The experimental results showed that this system was cheap, its operation was easy, it had wide adaptability, and the measurement results could fulfill the actual requirements.[著者文摘]

Key words:CCD; Size measurement; Error analysis; Image process; Threshold